Use and Care Manual

Page 8 of 12
OPERATING THE EVAPORATIVE COOLER
FILL THE RESERVOIR
Fill the reservoir with clean water through the Water Filler Door manually. To open the Water Filler
Door, depress the door at the center on the top edge of the door. Do not fill the water beyond the
maximum water level. Close Water Filler Door when the reservoir is filled.
Alternatively, connect a garden hose to the hose valve (use the hose adaptor provided) which also
provide continuous water fill.
The reservoir must be filled with a minimum volume of water before using the cooling function. The
water has to be at least half full on the Water Level Gauge.
USING ICE PACK (OPTIONAL)
Lift Top Water Tray Cover and place each frozen ice pack in each compartment on the tray to chill the
water before it flows through the Rigid Media Pad.
PLUG IN THE GFCI PLUG INTO AN GFCI ELECTRICAL OUTLET IF AVAILABLE
Note: The GFCI Plug can be plugged into an ordinary 110-115V electrical outlet.
Press the “Re-set” button on the GFCI plug first and connect the GFCI power plug to a GFCI electrical
outlet. Re-set GFCI outlet if necessary.
TO TURN ON THE EVAPORATIVE COOLER, TURN THE “FAN” ROTARY DIAL FROM “OFF” TO
“L, M OR H”.
USE THIS DIAL TO SELECT FAN SPEED.
TO ACTIVATE EVAPORATIVE COOLING, TURN “PUMP” DIAL FROM “OFF” TO “ON”.
Check the water level to ensure that the water level is sufficient for the operation.
TURN THE “SWING” DIAL FROM “OFF TO “ON” THE “OSC” BUTTON FOR THE AIRFLOW TO
OSCILLATE LEFT AND RIGHT.
Note: It is completely normal if the cooler has a slight odor or the water tank has slight discolouration
when it is used for the first time.