Datasheet

2-37
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: [phone] • FAX: [phone] •www.dialight.com
2
3mm Round
®
Optopipe
TM
Optical Light Pipe, 4 Array
515-1020
1.52
[.060]
2.34
[.092]
8.69
[.342]
15.09
[.592]
4.01
[.158]
1.35
[.053]
1.45
[.057]
1.70
[.067]
13.06
[.514]
3.56
[Ø.140]
6.35
[.250]
3.18
[.125]
3.61
[.142]
4.19
[.165
]
2.39
[.094]
2.00
[.079] TYP;
(3) PLACES
6.35
[.250]
22.66
[.892]
1.93
[.076 ±.002]
RECOMMENDED PIN HOLES AND SOLDER PAD
LAYOUT FOR SUGGESTED MicroLED LEDs
COMPONENT SIDE OF PRINTED CIRCUIT BOARD
3.00
[.118]
NOTE:
C.L. of
LED
3.56
[.140]
DIRECTION
OF LIGHT
Dimensions in mm [inches]
NOTE: designed for
post-reflow
PC board insertion.
Recommended
MicroLED SMT LEDs
for use with 515-1020
PART NO. COLOR PAGE #
597-3111-4xx AlGaAs Red 1-28
597-3201-4xx Orange 1-28
597-3311-4xx Green 1-28
597-3401-4xx Yellow 1-28
Features
• High transmissivity polycarbonate material
• UL94V-0 compliance
• ESD protection (circuit isolation from front panel)
• Wide viewing angle
• Arrays reduce insertion costs
• Secures to PCB by press-fit
• For Snap Pin Retention Version, see Dialight’s 515-1048
four Array Light Pipe
LED Data
For absolute maximum ratings and other
electrical and optical data on the recommended
LEDs, refer to LED data sheets.
Dialight Optopipe Light Pipe Description
This light pipe’s circular light emitting surfaces appear bright and have good optical isolation. It is reliably held in place
by 3 press-fit pins located between the light pipe elements. This Optopipe™ functions as a through-the-case indicator with
a textured finish on the 4 light emitting surface that increases its viewing angle. The recommended light sources are
Dialight's 597 Series PLCC-2 or PLCC-4 Type SMT LEDs. The LEDs are mounted in a straight line on a 0.250" pitch. The
light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe™ solutions for your applications.
Operating/Storage Temperature
–30°C to +100°C