Datasheet

2-29
Dialight Corporation • 1501 Route 34 South • Farmingdale, NJ 07727 • TEL: [phone] • FAX: [phone] •www.dialight.com
2
2.54mm Square
®
Optopipe
TM
Optical Light Pipe, 12 Array
515-1045
40.64
±
.08
[1.60
±
.003]
Ø 1.93
[.076]
±
.002
TYP; 4 PLCS
4.49
[.177] TYP
1.50
[.059] TYP
2.59
[.102] TYP
1.09
[.043] TYP
3.76 [.148]
TYP; 11
PLCS
.36
[.014]
4.06
[.160]
8.12
±
.08
[.320
±
.003]
20.06
[.790]
1.02 [.040]
ELEMENTS A F G L ONLY
61.98
[2.44]
ELEMENTS B C D E H I J K 10.41
[.410]
5.59
[.220]
3.18
[.125
]
TYP
8.10
[.319]
TYP
40.64
[1.60]
.35
[.014]
2.54 [.100]
TYP; 12
PLCS
43.94
[1.73]
3.76 [.148]
TYP; 11 PLCS
2.54
[.100]
TYP; 12
PLCS
A B C D E F G H I J K L
RECOMMENDED SOLDER PAD/HOLES LAYOUT
DIRECTION
OF LIGHT
POLISHED
FRONT
SURFACES
Dimensions in mm [inches]
MicroLED SMT LEDs
for use with 515-1045
PART NO. PAGE #
Recommended
597-3xx1-2xx 1-21
597-77x1-2xx 1-23 & 1-24
Alternatives
597-3xx1-5xx 1-30
597-77x1-5xx 1-31
LED alternatives may not produce optimum light
output
Solder Pad/Holes layout shown is for bi-color
LEDs listed under “Recommended” category
Contact factory for other layouts
Features
• High transmissivity polycarbonate material
• UL94V-0 compliance
• ESD protection (circuit isolation from front panel)
• Arrays reduce insertion costs
• Secures to PCB by press-fit
LED Data
For absolute maximum ratings and other electrical and optical
data on the recommended LEDs, refer to LED data sheets.
Dialight Optopipe Light Pipe Description
This Optopipe™ is held in place by 4 press-fit pins located in the corners of the device. Four of the elements are
slightly longer to fit into the panel openings; thereby, providing additional support for the Optopipe™. The LEDs are
mounted on a 3.76mm pitch. The recommended light sources are Dialight's 597 Series PLCC-2 or PLCC-4 Type SMT
LEDs. The light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom Optopipe™ solutions for your applications.
Operating/Storage Temperature
–30°C to +100°C
NOTE: designed for
post-reflow
PC board insertion.
NEW