Owner's manual

Document No.
9100-127-1383-99 Rev B
Release Date: 10/7/2010
_____________________________________________________________________
_____________________________________________________________________________
Dialight Corporation 1501 Route 34 South Farmingdale NJ 07727
Tel: [phone] Fax: [phone] Web: www.dialight.com
Page 25 of 25
Section 20: Commissioning Checklist
All items on checklist must be completed correctly to ensure the system
functions properly and reliably. Complete and Sign below.
□
Check that all cables, wires and connectors are connected securely in
accordance with Section 2 of the Installation Manual.
□
Check that the Lightning Protection and Proper Grounding is present in
accordance with Section 3 and 4 of the Installation Manual and per
Procedure for Proper Grounding to Minimize Risk of Lightning Damage
manual.
Operational Checks
A. Set system to Day mode.
1) □Pull out the interlock switch.
2) □ Wait at least 2 minutes.
3) □ Check RED Error LED (LED1) on Micro Board does NOT blink. If it
blinks , that indicates a fault, see Problem 2 and 3, in the Troubleshooting
Guide .
4) □ Check that the controller does not produce any alarm signals.
5) □ If possible, visually check the Light Engine is flashing and operating
normally .
B. Set system to RED Night mode.
1) □ Check LED1 on Red Driver module (bottom left of cabinet) is on if steady
burning and blinking if flashing .
2) □ Check that the controller does not produce any alarm signals.
3) □ If testing a white only system, set to White Night mode and repeat
step A , starting from step 2.
4) □ If possible, visually check the Light Engine lights up.
I, ________________________ (Print Name) , have completed all final checks listed
above and observed satisfactory results. No issues to report at this time.
__________________________________ ___________________________
Signature Date
__________________________________ ___________________________
Installation Site Location (Site Number, City, State) Company Name
ONCE COMPLETED, TEAR OFF AND TAPE INSIDE THE DOOR OF THE POWER SUPPLY!!