INSTALLATION AND MAINTENANCE MANUAL DUROSITE HIGH BAY LIGHT Model Versions HB-XXXX-EU A80-000726 ISSUE C
1: Introduction This High Bay light is designed for illumination of industrial locations. It uses the latest in solid state lighting technology for long life, low maintenance, and high efficiency. The unique optical design focuses light downward to where it is needed, giving improved efficiency over conventional HID,HPS and Induction luminaires. An internal power-factor-corrected switch-mode supply allows it to be used at a nominal 230/240VAC, 50/60Hz AC supply without any variation in light output.
Pendent Mount Installation Steps: • • • • • For maximum long term reliability and light output, the light must be installed in free air. The High Bay fixture design incorporates an over-temperature control circuit that reduces input power should internal temperatures reach a maximum level. As a result, light output may be reduced. The High Bay fixture is fitted with a 3 metre long cable that can be extended if required.
1) WARNING: TO AVOID FIRE AND ELECTRICAL SHOCK, TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT THE POWER IS OFF BEFORE WIRING. 2) Install occupancy sensor as per sensor instructions to provide desired coverage of area. 3) Connect luminaire wires per wiring diagram as follows: Brown lead to load of the occupancy sensor, Blue lead to the line (neutral), Green/Yellow lead to earth ground. Multiple fixtures may be connected to a sensor, as long as the rated load of the sensor is not exceeded.
4. Specifications Nominal AC Supply Voltage 230/240VAC, 50/60Hz Power consumption 150W typical Operating temperature range -40°C to +60°C [-40°F to +140°F] Power factor >0.95 ATHD <10% @230/240VAC Dimensions (Height x Diameter) Weight 12.7cm x 40.6cm [5” x 16”] 7.7 kg [17 lbs] DIMENSIONS ARE FOR REFERENCE ONLY. Page 5 of 6 Dialight Europe Ltd, Exning Road, Newmarket, Suffolk, CB8 0AX Tel: +44 1638 665161 Fax: +44 1638 660718 www.dialight.
All statements, technical information and recommendations contained herein are based on information and tests we believe to be reliable. The accuracy or completeness thereof is not guaranteed. In accordance with Dialight “Terms and Conditions of Sale”, and since conditions of use are outside our control, the purchaser should determine the suitability of the product for his intended use and assumes all risk and liability whatsoever in connection therewith.