INSTALLATION AND MAINTENANCE MANUAL DUROSITETM SERIES LED LOW BAY Document No: 9100-127-1485-99 Rev A February 2011 Model Versions LBW-XXXX-EU
Document No: 9100-127-1485-99 Rev A 1: Introduction This Low Bay light is designed for illumination of industrial locations. It uses the latest in solid state lighting technology for long life, low maintenance, and high efficiency. The unique optical design focuses light downward to where it is needed, giving improved efficiency over conventional HID, HPS and Induction luminaires.
Document No: 9100-127-1485-99 Rev A Pendent Mount Installation Steps: • • • • For maximum long term reliability and light output, the light must be installed in free air. The Low Bay fixture design incorporates an over-temperature control circuit that reduces input power should internal temperatures reach a maximum level. As a result, light output may be reduced. The Low Bay fixture is fitted with a 3 metre long cable that can be extended if required.
Document No: 9100-127-1485-99 Rev A 2) Install occupancy sensor as per sensor instructions to provide desired coverage of area. 3) Connect luminaire wires per wiring diagram as follows: Brown lead to load of the occupancy sensor, Blue lead to the Line (Neutral), Green/Yellow lead to Earth Ground. Multiple fixtures may be connected to a sensor, as long as the rated load of the sensor is not exceeded. 4) Restore power at circuit breaker or fuse. 5) Verify operation of system.
Document No: 9100-127-1485-99 Rev A 4: Specifications Nominal AC Supply Voltage 230/240VAC, 50/60Hz Power consumption 80W nominal Operating temperature range -40°C to +60°C [-40°F to +140°F] Power factor >0.9 ATHD <15% Dimensions (Height x Diameter) 20.3cm x 40.6cm [8” x 16”] Weight 8.2 kg [18 lbs] DIMENSIONS ARE FOR REFERENCE ONLY. All statements, technical information and recommendations contained herein are based on information and tests we believe to be reliable.
