Data Sheet

DA14531MOD
SmartBond TINY
TM
Module
Error! Unknown document
property name.
Datasheet
CFR0011-120-00
3 of 4
© 2020
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help.
ISED statements:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation
of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNRd’
Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de
licence. L’ exploitation est autorisée aux deux conditions suivantes :
1) L’ appareil ne doit pas produire de brouillage;
2) L’ appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptibled’en
compromettre le fonctionnement.
The system integrator must place an exterior label on the outside of the final product housing the
DA14531MOD-00F0100 Modules. Below is the contents that must be included on this label.
OEM Labeling Requirements:
NOTICE: The OEM must make sure that FCC labeling requirements are met. This includes a clearly visible
exterior label on the outside of the final product housing that displays the contents shown in below:
Model: DA14531MOD-00F0100
Contains FCC ID: Y82-DA14531MOD
Contains IC: 9576A-DA14531MOD