Network Card User Manual
Table Of Contents
- Dialogic® DSI SS7MD Network Interface Board Programmer's Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Specification
- Chapter 3: Installation
- Chapter 4: Dialogic® DSI SS7MD Board Configuration and Operation
- 4.1 Regulatory and Geographic Considerations
- 4.2 System Structure
- 4.3 Running Host Binaries With Dialogic® DSI SS7MD Board
- 4.4 System Configuration
- 4.5 Protocol Configuration
- 4.6 Monitoring
- 4.7 ATM Monitoring
- 4.8 Switching Timeslots between LIUs
- 4.9 Received Message Timestamping
- 4.10 High Speed Link Operation
- 4.11 Operation of the Thermal Sensor
- Chapter 5: Program Execution
- Chapter 6: Message Reference
- Chapter 7: Configuration Command Reference
- 7.1 Physical Interface Configuration Commands
- 7.2 Monitor Configuration Commands
- 7.3 MTP Configuration Commands
- 7.4 ATM Configuration Commands
- 7.5 ISUP Configuration Commands
- 7.6 TUP Configuration Commands
- 7.7 SCCP Configuration Commands
- 7.8 DTC Configuration Commands
- 7.9 TCAP Configuration Commands
- 7.10 MAP Configuration Commands
- 7.11 INAP Configuration Commands
- 7.12 IS41 Configuration Commands
- Chapter 8: Host Utilities
- Appendix A: Protocol Configuration Using Discrete Messages
- Appendix B: Thermal guidelines for selecting suitable servers for use with a Dialogic® DSI SS7MDL4 Network Interface Board
- Glossary
- Index
189
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
LIU_MSG_R_CONFIG message 63
LIU_MSG_R_CONTROL message 64
LIU_MSG_R_STATE message 109
LIU_MSG_R_STATS message 110
LIU_SC_DRIVE 122
LIUs
switching timeslots 36
log utility 162
logging
s7_log 27
M
MAP configuration commands
MAP_CONFIG 157
MAP_TRACE 157
MAP_CONFIG configuration command 157
MAP_TRACE
general configuration command 157
MAP_TRACE command 157
message reference 47
message summary table 115
messages
API_MSG_CNF_IND 105
API_MSG_RX_IND 74
API_MSG_RX_INDT 75
API_MSG_TX_REQ 76
ATM_MSG_AAL_CFG_MON_LINK 84
ATM_MSG_AAL_END_LINK 85
ATM_MSG_CFG_STREAM 80
ATM_MSG_CONFIG 78
ATM_MSG_END_STREAM 82
ATM_MSG_LINK_STAT 88, 89, 90, 92
ATM_MSG_R_AAL_LINK_STATS 86
ATM_MSG_R_STREAM_STATS 82
ATM_MSG_STREAM_STATE 87
DVR_MSG_R_L1_STATS 113
GEN_MSG_MOD_IDENT 77
LIU_MSG_CONFIG 59
LIU_MSG_CONTROL 62
LIU_MSG_R_CONFIG 63
LIU_MSG_R_CONTROL 64
LIU_MSG_R_STATE 109
LIU_MSG_R_STATS 110
MGT_MSG_CONFIG0 53
MGT_MSG_L1_CONFIG 54
MGT_MSG_L1_END
56
MGT_MSG_NTP_CONFIG 56
MGT_MSG_NTP_SYNC 108
MGT_MSG_R_BRDINFO 112
MGT_MSG_SS7_EVENT 107
MVD_MSC_SC_DRIVE_LIU 69
MVD_MSG_LIU_STATUS 106
MVD_MSG_RESETSWX 64
MVD_MSG_SC_CONNECT 65
MVD_MSG_SC_LISTEN 70
MVD_MSG_SC_MULTI_CONNECT 68
SS7_MSG_CONFIG 72
SSD_MSG_BOARD_INFO 52
SSD_MSG_RESET 49
SSD_MSG_RST_BOARD 50
SSD_MSG_STATE_IND 104
MGT_MSG_CONFIG0 message 53
MGT_MSG_L1_CONFIG message 54
MGT_MSG_L1_END message 56
MGT_MSG_NTP_CONFIG 56
MGT_MSG_NTP_CONFIG message 56
MGT_MSG_NTP_SYNC message 108
MGT_MSG_R_BRDINFO message 112
MGT_MSG_SS7_EVENT message 107
MONITOR_LINK 127
monitoring 34
API_MSG_RX_IND 74
API_MSG_RX_INDT 75
configuration 34
configuring the LIU type 120
high_Z parameter in LIU configuration 61
runtime operations 34
MTBF 14
MTP configuration commands
MTP_LINK 131
MTP_LINKSET 131
MTP_ROUTE 134
MTP_USER_PART 135
MTP_LINK configuration command 131
MTP_LINKSET configuration command 131
MTP_ROUTE configuration command 134
MTP_USER_PART configuration command 135
MVD_MSG_LIU_STATUS message 106
MVD_MSG_RESETSWX message 64
MVD_MSG_SC_CONNECT message 65
MVD_MSG_SC_LISTEN
example code 37
MVD_MSG_SC_MULTI_CONNECT message 68
P
PCI address mode 173
physical interface configuration commands
LIU_CONFIG 119, 122
SS7_BOARD 119
physical interfaces
DSI SS7MDL4 boards 12
play command utility 165
power requirements
DSI SS7MDL4 boards 13
processes
on host 27
program execution
Linux 45
Solaris 45
protocol configuration 32
s7_mgt utility 32
protocol support
DSI SS7MDL4 boards 12
R
regulatory and geographic considerations 26
reliability information