Network Card User Manual
Table Of Contents
- Dialogic® DSI SS7MD Network Interface Board Programmer's Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Specification
- Chapter 3: Installation
- Chapter 4: Dialogic® DSI SS7MD Board Configuration and Operation
- 4.1 Regulatory and Geographic Considerations
- 4.2 System Structure
- 4.3 Running Host Binaries With Dialogic® DSI SS7MD Board
- 4.4 System Configuration
- 4.5 Protocol Configuration
- 4.6 Monitoring
- 4.7 ATM Monitoring
- 4.8 Switching Timeslots between LIUs
- 4.9 Received Message Timestamping
- 4.10 High Speed Link Operation
- 4.11 Operation of the Thermal Sensor
- Chapter 5: Program Execution
- Chapter 6: Message Reference
- Chapter 7: Configuration Command Reference
- 7.1 Physical Interface Configuration Commands
- 7.2 Monitor Configuration Commands
- 7.3 MTP Configuration Commands
- 7.4 ATM Configuration Commands
- 7.5 ISUP Configuration Commands
- 7.6 TUP Configuration Commands
- 7.7 SCCP Configuration Commands
- 7.8 DTC Configuration Commands
- 7.9 TCAP Configuration Commands
- 7.10 MAP Configuration Commands
- 7.11 INAP Configuration Commands
- 7.12 IS41 Configuration Commands
- Chapter 8: Host Utilities
- Appendix A: Protocol Configuration Using Discrete Messages
- Appendix B: Thermal guidelines for selecting suitable servers for use with a Dialogic® DSI SS7MDL4 Network Interface Board
- Glossary
- Index
49
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
6.2 General Configuration Messages
General configuration messages are typically issued by the s7_mgt protocol configuration utility, in which case
they need not, and should not, be generated by any user application software.
If the user elects not to use the s7_mgt protocol configuration utility, it is necessary for the application to
build and send messages that:
• configure the ssd module
• reset each board
• configure each board
• optionally configure additional routes
The messages in the general configuration category include:
• SSD_MSG_RESET - SSD Reset Request
• SSD_MSG_RST_BOARD - Board Reset Request
• SSD_MSG_BOARD_INFO - Board Information Request
• MGT_MSG_CONFIG0 - Board Configuration Request
• MGT_MSG_L1_CONFIG - Layer 1 Configuration Request
• MGT_MSG_L1_END - Layer 1 Configuration End
• MGT_MSG_NTP_CONFIG - Network Time Configuration
6.2.1 SSD_MSG_RESET – SSD Reset Request
Synopsis
Sets up ssd module run-time options at initialization time.
Note: When using the s7_mgt protocol configuration utility, this message is generated by s7_mgt and
should not be generated by the user.
Format
Description
This message is used during initialization by the application to reset the ssd module and set up its run-time
parameters.
The confirmation message (if requested) indicates success with a status value of 0.
MESSAGE HEADER
Field Name Meaning
type SSD_MSG_RESET (0x7680)
id 0
src Sending module ID
dst SSD_module_ID
rsp_req Used to request a confirmation.
hclass 0
status 0
err_info 0
len 24
PARAMETER AREA
Offset Size Name
0 1 Reserved. Set to 0.
1 2 Reserved. Set to 0.
3 1 mgmt_id
4 18 Reserved. Set to 0.
22 2 num_boards