Network Card User Manual
Table Of Contents
- Dialogic® DSI SS7MD Network Interface Board Programmer's Manual
- Contents
- Chapter 1: Introduction
- Chapter 2: Specification
- Chapter 3: Installation
- Chapter 4: Dialogic® DSI SS7MD Board Configuration and Operation
- 4.1 Regulatory and Geographic Considerations
- 4.2 System Structure
- 4.3 Running Host Binaries With Dialogic® DSI SS7MD Board
- 4.4 System Configuration
- 4.5 Protocol Configuration
- 4.6 Monitoring
- 4.7 ATM Monitoring
- 4.8 Switching Timeslots between LIUs
- 4.9 Received Message Timestamping
- 4.10 High Speed Link Operation
- 4.11 Operation of the Thermal Sensor
- Chapter 5: Program Execution
- Chapter 6: Message Reference
- Chapter 7: Configuration Command Reference
- 7.1 Physical Interface Configuration Commands
- 7.2 Monitor Configuration Commands
- 7.3 MTP Configuration Commands
- 7.4 ATM Configuration Commands
- 7.5 ISUP Configuration Commands
- 7.6 TUP Configuration Commands
- 7.7 SCCP Configuration Commands
- 7.8 DTC Configuration Commands
- 7.9 TCAP Configuration Commands
- 7.10 MAP Configuration Commands
- 7.11 INAP Configuration Commands
- 7.12 IS41 Configuration Commands
- Chapter 8: Host Utilities
- Appendix A: Protocol Configuration Using Discrete Messages
- Appendix B: Thermal guidelines for selecting suitable servers for use with a Dialogic® DSI SS7MDL4 Network Interface Board
- Glossary
- Index
90
6 Message Reference
• num_links
Maximum number of Q.SAAL signaling links to support on this board. This may range from 0 to one less
than the maximum number of links supported depending on how many signaling links the user wishes to
use. It is not necessary to always use this number of links.
6.6.2 QSL_MSG_CFG_LINK – Configure Q.SAAL Link
Synopsis
Message issued by management to configure an individual Q.SAAL link for operation.
Message Format
Description
This message is used to configure the operational parameters for an individual Q.SAAL link and to cause the
power up action defined in Q.2140/Q.2110 to be executed. One such message must be issued to Q.SAAL
(after the SS7_MSG_RESET message has been issued) for each link to be used. Subsequent
MESSAGE HEADER
Field Name Meaning
type QSL_MSG_CFG_LINK (0x7267)
id Link ID
src User Module ID
dst QSL_TASK_ID
rsp_req Used to request a confirmation
hclass 0
status 0
err_info 0
len 45
PARAMETER AREA
Offset Size Name
0 2 options
2 2 upper_link_id
4 2 cell_stream_id
6 1 upper_mod_id
72vpi
92vci
11 1 mgmt_id
12 1 lower_mod_id
13 2 max_SIF_len
15 2 cong_onset
17 2 cong_abate
19 2 cong_discard
21 2 maxcc
23 2 maxpd
25 2 n1
27 2 co1
29 2 co2
31 2 co3
33 2 ca1
35 2 ca2
37 2 ca3
39 2 cd1
41 2 cd2
43 2 cd3