User manual

Chapter 6 Command Definitions

Syntax

ALLIP;

Prerequisites

None

Attributes

None

Examples

ALLIP;

Output Format

SYSTEMIDENT1 Alarm List (active alarms) 1996-12-01 00:00:54

ALP CODE ID DIAG CLA OCCURRED CLEARED TITLE

107 1 103 0 5 A 2001-10-30 10:54:48 PCM loss

74 1 104 0 4 A 2001-10-30 10:54:27 PCM loss

EXECUTED

6.4.5 ALLOP – Alarm Log Print

Synopsis

This command gives a printout of the alarm log. If no code or class is entered, the whole log is output.

Each fault code (CODE) is associated with an alarm class (CLA) which may be Minor, Major or Critical. The

alarm class in turn governs which alarm LED, relay or SNMP alarm that is activated when the condition

exists.

The command provides and indication of the time the alarm occurred (OCCURRED) and, if it has done so, the

time the alarm cleared (CLEARED). The output from the command indicates, the alarm class (CLA indicating

either a System, PCM or signaling failure) as well as an alarm code specific identifier (ID) and a diagnostic

field (DIAG). The C or A character in the CLA field indicates the current status as either A (active) or C

(cleared).

See Chapter 8, “Alarm Fault Code Listing” for definitions of the alarm code specific parameters.

Syntax

ALLOP[:CODE=…];

ALLOP[:CLA=…];

Prerequisites

None

Attributes

None

Examples

ALLOP:CODE=20;

ALLOP:CLA=1&&2;

ALLOP;