User manual

58
Chapter 6 Command Definitions
6.5.5 CNMOI – Configuration Monitor Initiate
Synopsis
This command initiates the monitoring of an object on the Signaling Gateway. An object is currently a
C7LINK.
For signaling, the STS monitors information sent from the EQU of the signaling link and the RTS monitors
information received by the signaling link.
Syntax
CNMOI:C7LINK=,STS=,RTS=;
Prerequisites
• If specified, the C7LINK has already been initiated and must have a TS and EQU.
• The PCM on which STS exists must have already been initiated and STS must be within the correct range
for the PCM type (0 to 31 for E1 and 1 to 24 for T1 PCMs).
• The PCM on which RTS exists must have already been initiated and RTS must be within the correct range
for the PCM type (0 to 31 for E1 and 1 to 24 for T1 PCMs).
• STS is not already assigned elsewhere on the system for output.
• RTS is not already assigned elsewhere on the system for output.
• A signaling link can only be monitored once.
Attributes
CONFIG
Examples
CNMOI:C7LINK=1,STS=3-3-15,RTS=5-3-16;
6.5.6 CNMOE – Configuration Monitor End
Synopsis
This command ends the monitoring of an object. An object is currently only an signaling link.
Syntax
CNMOE:C7LINK=;
Prerequisites
• The C7LINK is being monitored.
Attributes
CONFIG
Examples
CNMOE:C7LINK=1;