User manual
97
Dialogic
®
DSI Signaling Server SGW Mode User Manual Issue 5
Attributes
None
Examples
MSC7P:C7LINK=1;
MSC7P;
Output Format
SS7 Link Traffic Measurements (Page 1 of 2)
C7LINK OSSDUR RXNACK RXMSU RXOCT TXMSU TXOCT RTXOCT NCONG PERIOD
1 0 0 188 4136 188 4136 0 0 00:46:39
2 0 0 188 4136 188 4136 0 0 00:46:39
3 0 0 0 0 0 0 0 0 00:46:39
EXECUTED
SS7 Link Traffic Measurements (Page 2 of 2)
C7LINK ALIGN SUERR TBUSY TCONG NDISCARD NEVENT PERIOD
1 0 0 0 0 0 0 00:46:39
2 0 0 0 0 0 0 00:46:39
3 92 0 0 0 0 0 00:46:39
EXECUTED
6.10.2 MSEPP – Measurement Ethernet Port Print
Synopsis
This command prints the traffic measurements for each Ethernet port on the system taken over a period of
time. The meaning of each field in the output is as follows:
The meaning of each field in the output is as follows:
• ETH - Ethernet port number.
• RXKBTYE - Number of kilobytes of data received (in kilobytes)
• RXPKT - Number of packets of data received
• RXERR - Number of receive errors detected
• RXDROP - Number of received packets dropped by the device driver during the measurement period
• TXKBTYE - Number of kilobytes of data transmitted (in kilobytes)
• TXPKT - Number of packets of data transmitted
• TXERR - Number of transmit errors detected
• TXDROP - Number of transmit packets
• PERIOD - The period over which the measurement was taken
• RXFIFO - The number of FIFO buffer errors received
• RXFRAME - The number of packet framing errors received
• RXCOMP - The number of compressed packets received
• RXMULT - The number of multicast frames received
• TXFIFO - The number of FIFO buffer error transmitted
• TXCOLLS - The number of collisions detected on the transmit side
• TXCARRIER - The number of carrier losses detected on the transmit side
• TXCOMP - The number of compressed packets transmitted
Note: Values are reset using the RESET parameter. MSEPP:RESET=Y; resets the measurement values
to 0.