User`s guide

Dialogic
®
System Release 6.0 PCI for Windows
®
Release Update, Rev 62 — January 30, 2008 399
Dialogic Corporation
The cc_GetDLinkState( ) function retrieves the logical data link state (operable or inoperable) of
the specified board device for PRI or station device for BRI.
In the description of the state_buf parameter for the cc_GetDLinkState( ) function, only
two possible data link states are defined: DATA_LINK_UP and DATA_LINK_DOWN.
DATA_LINK_DISABLED is not a valid value (PTR# 25745).
In the cc_MakeCall( ) function reference information, the description of the numberstr
parameter is replaced by the following (PTR# 22842):
The destination (called party’s) telephone number string. The maximum number of digits is
dictated by the protocol switch specification. Users need to find out the specification limits for the
protocol they wish to use, otherwise the protocol stack will reject the request to make a call.
3.4.20 Dialogic
®
Modular Station Interface API Library Reference
Update to ms_SendData( )
The following information is added to the description of the ms_SendData( ) function:
Make sure an interval of at least 2 seconds elapses between the reception of an MSEV_RING event
with MSMM_RNGOFFHK event data and a call to the ms_SendData( ) function to ensure reliable
reception of call waiting caller ID. If there is still a problem receiving the call waiting caller ID, it
may be due to the configuration of the phone.
Update to MS_CDT data structure (PTR# 35565)
A note should be added to the MS_CDT chan_sel field indicating that
MSPN_STATION is supported on Dialogic
®
Springware Boards only and MSPN_TS is
supported on Dialogic
®
DI, HDSI, and Springware Boards.
Update for new event
Because of a new feature in the Service Update, information about the
MSEV_CHANSTATE event should be added to the descriptions of the
ms_setevtmsk( ) and ms_getevtmsk( ) functions and to the Events chapter. For
information about this feature, see Section 1.66, “New Station Interface Alarms”, on
page 239 of this Release Update.
3.4.21 Dialogic
®
Modular Station Interface API Programming
Guide
Because of a new feature in the Service Update, information about the
MSEV_CHANSTATE event should be added to the Event Handling chapter. For
information about this feature, see Section 1.66, “New Station Interface Alarms”, on page
239 of this Release Update.
3.4.22 Dialogic
®
PBX Integration Board User's Guide
PBX Integration Support for Nortel BCM
Because of enhancements introduced in the Service Update, the Nortel Business
Communications Manager (BCM) is now supported when using the Dialogic
®
D/82JCT-U Board. For information about this feature, including programming