Specifications

4
4
4
Hardware Installation
Your monitor is equipped with a power supply with a voltage range from 100 to
240 Volts AC at a frequency of 50 to 60 Hz. Make sure that your local power
supply is within the supported range. If you are unsure, please contact your
electricity supplier.
To install your Diamond Digital DV226BW monitor:
1. Please ensure the computer and monitor power cables are both unplugged.
2. Attach the monitor’s D-sub signal cable to the VGA output on the
videocard, located at the back of the computer. Attach the other end to your
LCD monitor.
3. If a DVI port is available on your videocard, you should use this instead of
the D-sub (VGA) port. The DVI port will provide crisper text and a clearer
picture.
4. Connect the stereo audio cable from the audio jack on the monitor to the
audio output of your computer’s sound card.
5. Connect the power cord from the monitor’s power jack to an AC power
socket. Please make sure that you have easy access to the power socket
so you can disconnect the unit from the power socket if needed.