Installation Guide

ManualsBrandsDiamond NOW ManualsKitchen Cabinets22 U24R

Instructions for 90" Tall Cabinet Installation

Remove base board and other objects on

the wall area where the cabinets are to be

installed. Using a straight edge and a level,

find the high spot in the floor where the

cabinets are to be installed. From the high

spot, mark a level horizontal line on each

wall where the cabinets will be attached.

From the level lines mark another parallel

level horizontal line 35" up for base and

90" up for tall and wall cabinets.

The top of the base, tall and wall

cabinets will be located at these marks.

Stand 90" tall cabinet upright near desired

installation locaton. Position the toe kick

assembly with toe kick board in front.

Slide toe kick assembly underneath tall cabinet.

(Note: a piece of 1/4" material can be placed

on top of toe kick assembly panel to aide

in sliding toe kick assembly underneath the tall

cabinet.) Align right, left and back sides of

toe kick assembly flush with cabinet.

Locate the studs with a studfinder and mark

where the cabinets are to be installed.

Remove all the doors and drawers from the

cabinets before installation.

STEP 1

STEP 2

STEP 3

Mark top line

for wall, tall

cabinets

Plumb

line

Corner is out

of plumb

(not vertical)

Corner is out

of plumb

Floor not level

High point

Use level to

draw line

Level, straight edge

Parts Included:

86" Cabinet

4" Toe Kick Assembly

8 #10 x 2 1/2" Screws

Parts Needed:

#6 x 2 1/2" Screws

10/30/08 KC5072 R1

Note: The use of nails in the installation of this cabinet voids all guarantees, written or implied.

Tools Needed:

Phillips Head Screwdriver

#2 Phillips Bit

Drill with 1/16" & 3/32" Bit

Marking Tool

Level

Studfinder

C-clamps

Tape Measure

Summary of content (3 pages)

PAGE 1
Instructions for 90" Tall Cabinet Installation Parts Included: Tools Needed: Parts Needed: 86" Cabinet 4" Toe Kick Assembly 8 #10 x 2 1/2" Screws Phillips Head Screwdriver #2 Phillips Bit Drill with 1/16" & 3/32" Bit Marking Tool Level Studfinder C-clamps Tape Measure #6 x 2 1/2" Screws Note: The use of nails in the installation of this cabinet voids all guarantees, written or implied.
PAGE 2
STEP 4 STEP 5 STEP 6 Using the dimensions shown, mark the bottom of tall cabinet for predrilling. Measure 1" from inside of end panel and 6" from inside of face frame in the front. In the back of cabinet, measure 1" from inside of end panel and 3" from back panel. Mark the holes on both the left and right sides of tall cabinet bottom. Make sure the toe kick assembly is flush with the cabinet. With a 3/32" drill bit, drill starter holes using the four marks that were made on the bottom.
PAGE 3
STEP 8 10/30/08 Run the #10 x 2 1/2" screws into the holes until they are nearly tight. Must use a #2 phillips bit when fastening the #10 x 2 1/2" screws. Make sure the back is fully supported with shims, as needed, and does not bow into any imperfections in the wall. Check the cabinet for level and plumb and adjust as needed. Tighten the screws fully and recheck for level and plumb. Reinstall the cabinet doors and drawers. Install hardware if needed.