Blind Corner Base Cabinet Install Instructions

(6.18.13) SCB INSTRUCTIONS A5131

STEP 2

STEP 3

STEP 4

The blind panel will need to be trimmed to size to fit

over the opening of your square corner base cabinet.

Then the blind panel will need to be drilled for

installation. Mark the (8) hole locations shown to the

right on the blind panel. All holes should be located

1/4" from edges of blind panel. Drill the (8)

premarked locations with a 7/64" diameter drill bit

through the panel.

*Panel is located under cabinet with Filler Board

Locate the studs with a stud finder and mark where

the cabinets are to be installed. Remove all the doors

and drawers from the cabinets before installation.

Measure the area to confirm that the kitchen design

used will work.

Remove door and drawer from square corner

cabinet. On the square corner opening side

of the face frame (opening without door

attached), a line 1/2” from the edge of the

opening needs to be marked onto the face

frame. This will locate the blind panel for

attachment.

NOTE: Door can be placed on either side of

the cabinet depending on design needs.

DOOR LOCATION

FACE FRAME

1/2