Blind Corner Base Cabinet Install Instructions

(6.18.13) SCB INSTRUCTIONS A5131
STEP 11
STEP 12
STEP 13
With the adjacent cabinet removed, the Filler Board
can be clamped to the square corner cabinet in the
position marked in the previous step. Drill two 3/32”
holes into the filler board through the face frame of
the cabinet. Then use 2 #8 cabinet screws of the
appropriate length depending on the width of your
filler board if you cut to fit your design layout. If the
Filler Board’s width was not cut down, use 2” long
#8 cabinet screws.
Once the square corner cabinet has been installed,
the adjacent base cabinets can now be installed.
Start installing the base cabinets in the corner.
Using clamps, align and join the cabinets together
at the face frames. Make sure that the face frames
align both on the face and vertically.
Check the cabinet to ensure it is level and plumb.
Shim to fill uneven areas between the floor and
base of the cabinet and between the wall and the
back of the cabinet. Failure to do this step could
result in damage to the cabinet.
Follow Step 9 to secure adjacent cabinet to the
wall.
With the adjacent cabinet positioned next to the
installed square corner cabinet, mark the location
of the filler board on the inside of the square corner
cabinet face frame.
SQUARE CORNER
CABINET
ADJACENT
CABINET
Filler Board
Wall
=Open Space
Pencil
SQUARE CORNER
CABINET
Filler Board
Wall
Clamp
Shims