User Manual

KA-08-034.0
CANtrak 2600 AND 2610
HArdwAre
Micro Controller
FLASHMemory
RAM
EEPROM
Siemens164,16bit/20Mhz
512K bytes
128Kbytes
2600-2Kbytes;26102K+32Kbytes
electricAl
Display
Resolution
PowerRequirements
Power Consumption
Audible Alarm
External output
Wiring Protection
Connection
Communications
FSTN
160x128pixels
10 to 32 VDC supply (reverse polarity protected)
40mA (backlight off) 160mA (backlight on) at 12VDC
4kHzInternalsounder
Open collector, internal driver (CANtrak 2610 only) 500mA
Polarityreverseprotected(Fusemustbeincluded)
Integral Deutsch 12 way connector (DT04-12PA)
FullCAN2.0Bcontroller/port.RS232,J1587/J1587(RS485)
environmentAl
Operating temperature
Storage Temperature
Degree of Protection
Salt Spray
EMC
2600:-25°Cto+75°C2610:-40ºCto+75ºC
-40°Cto+80°C
IP67
IEC60068-2-52:1996
IEC 61000 and EN55022
mecHAnicAl
Case material
Dimensions
ABShousingandacryliclens
110mmx110mmx38.5mmdeep(4.33”x4.33”x1.5”)withoutconnector
pArt numbers
CANtrak 2600
CANtrak 2610
900601
900602
MOUNTING AND DIMENSIONAL INFORMATION
• Excellentsunlight
readability
• IntegralDeutsch12way
connector
• Internal500mAopen
collector output driver
(possible for external
output alarm)
– Model 2610 only
• ConnectorPin
Identification:
1. Power –ve
2. Power+ve
3. RS232TX(+)
4. RS232TX(-)
5. RS232RX(-)
6. RS232RX(+)
7. CANLO
8. CANHI
9.J1708/J1587A
10.J1708/J1587B
11. Switched output
(2610 only)
12.NotUsed
SPECIFICATIONS & TECHNICAL DATA
29