Manual

3. Turn knob till its stops, this ensures that
transmission is engaged.
Disengaging Transmission
1. Place speed control lever in the neutral
position.
2. Locate Transmission Engagement Knob in
the center of the dash.
3. Turn Engagement Knob to the right to
disengage transmission
4. Transmission is disengaged when machine
will free roll. NOTE: DO NOT disengage
transmission unless saw is on level ground
and parking brake is set.
Transmission Engagement Knob
Fuel System
• DO NOT operate the saw with a fuel leak.
• DO NOT refuel saw with the engine
running.
• DO NOT smoke or expose
fuel to open flame when
filling the fuel tank and/or
working on fuel system.
• DO NOT overfill fuel tank. Cleanup any
spilled fuel prior to starting the machine.
• NOTE: Fuel may seep from fuel vent cap
when saw is raised to its upright position if
overfilled with fuel, cleanup any fuel
spillage.
Adding Fuel
Check fuel level daily and fill as necessary, avoid
running machine out of fuel.
1. Lower the saw so that it is level with
ground.
2. Stop the engine and allow time to cool
down.
3. Remove fuel cap.
4. Fill the fuel tank with low sulfur or ultra low
sulfur diesel fuel only. The fuel tank has a
capacity of nine gallons.
5. Replace fuel cap and tighten to secure.
Cold Weather Fuel
Diesel fuel can become thick in cold weather,
resulting in clogs in the fuel system; refer to the
Deutz Operation manual for a list of appropriate
cold weather fuels.
Storage
Fill the fuel tank to prevent condensation and
contamination in the tank for short storage
intervals. For long periods of storage, drain the fuel
tank and lines.
Engine
• DO NOT leave engine running
while machine is unattended.
• Operate saw in a well
ventilated area, concentrated
exhaust can cause loss of consciousness
and/or death.
Engine Governor
A manufacturer set governor controls the engines
maximum speed. DO NOT adjust the governor
setting unless blade size has changed and would
require a different maximum engine speed.
Ignition Switch
The ignition switch is located on the dash panel of
the CG-2 machine. This is a multi-function switch
and operates as follows:
•
Auxiliary: Creates power, but does not start
the engine.
• Off: Turns engine off.
•
Run: Creates power, but does not start the
engine.
•
Pre-Heat: Warms engines glow plugs which
help the engine start in cold weather.
•
Start: Turns engine on. DO NOT engage
Start for long periods of time, this can
cause overheating or damage to the starter.
If engine does not start right away, release
the key and try several minutes later. Refer
to the Fault Table in the Deutz manual if
engine does not start after two attempts.
13