User guide

Blade removal and installation
Step 11: Reinstall adjustable arm assembly, blade guard and splash flap on saw.
Hand tighten bolts. Place ring saw on flat surface (figure 11) so that the
adjustable arm assembly is sitting with the weight of the saw on it. Tighten bolts
using the 9/16” wrench provided. Guide rollers should be firmly in contact with
the blade. Move t-handle to original location by pulling up and rotating 90
degrees, returning transmission assembly to the tensioned position.
Figure 11
Step 12: Lay saw flat on table and reinspect blade for play at the guide rollers.
Repeat step 11 if blade is not in firm contact with guide rollers.