Owner's manual

Controls
Side Control Panel
1. Strobe Light – Powers strobe light.
2. Power Indicator - Indicates power supply to
machine.
3. Vacuum Switch – Turns vacuum pump ON/OFF.
4. Rear Stabilizer Switch – Raises and lowers rear
stabilizer.
5. Vacuum Lift Switch – Raises and lowers vacuum
base.
6. Digital Readout – Indicates Bit RPM.
7. Auto Drill Switch – Locks the drill down function
until cylinder reaches maximum length, or until
switch is turned off. Drill Down, Drill Up, and Turbo
buttons do not work when Auto Drill switch is
activated.
8. Drill Up Push Button – Raises Core Bit.
9. Emergency Stop – Stops engine and all systems of
machine.
10. Drill Down Pushbutton – Lowers core bit.
11. Pressure Switch Adjuster –Adjust pressure to core
bit.
12. Vacuum Valve – Holds or releases vacuum.
13. Vacuum Gauge – Indicates vacuum pressure.
14. 3000 PSI Pressure Gauge – Indicates drive motor,
drill motor, or hydraulic outlet pressure.
15. Pressure Indicator- Indicates too much pressure is
being applied to core bit.
16. Turbo Button – Raises or lowers core bit at
maximum speed. Turbo button must be pressed
while holding Drill Down or Drill Up to indicate
direction. Turbo button does not work when Auto
Drill switch is activated
17. 500 PSI Pressure Gauge- Indicates cylinder
pressure when drilling.
18. Drill RPM Adjustment – Increases or decreases core
bit rpm.
19. Cylinder Speed Adjuster – Increases or decreases
core bit’s maximum raise and lower speed.
20. Work Light – Powers work light on mast.
21. Water Pump Switch – Turns water pump ON/OFF.
6