Manual

Page 8
Starting the machine
To start cutting perform the following steps:
 Make sure there is sufficient tension is on wire.
 Screw out the travel pressure control knob (FIG. 10) of the BS-2/ BS
control. The travel pressure valve is used to increase and decrease wire
tension.
 Engage Direction Lever A (FIG. 10) so tension is set.
 Turn on the main hydraulic flow slowly (Saw Motor Control – see FIG. 8).
The wire should start to move.
 Slowly turn in the Main Pressure Valve (increase pressure) ensuring that
the pressure does not exceed 1,800psi while the wire is spinning.
 Adjust the travel pressure valve as needed to keep the wire running at the
proper tension.
FIG. 10