Instruction manual

The Phoenix II will now display the message “Tuning Loops” followed by “Waiting for Any Vehicle”. Once a vehicle has

passed and the data viewed is correct, press ENTER to continue.

From here, the final start questions are asked.

4.c.5. Questions Asked With Count Storage Mode

The following questions are asked for each lane you have enabled.

Enter the appropriate information for this lane, up to 15 characters. This info is

normally used to indicate lane direction.

Choices are Axle or Loop. This question is only asked if you have a loop board

installed in the counter.

If you are setting an odd numbered lane, the counter asks:

Choices depend on Lane Sensor. If Axle, choices are Normal, Direction, or

Subtract. If Loop, choices are Normal or Direction. Selecting anything other

than Normal will indicate that you are using this lane in conjunction with the next

lane to get count. This causes the counter to automatically configure the next

lane to be the same as this lane.

If you are selecting an Axle Sensor:

Select Yes or No to automatically divide the total count by two, or count individual

axles.

After the lanes have been entered, the following questions are asked:

Select how many intervals…

Enter the length of the record interval you want to use.

After entering the interval information, the Phoenix II will display “Tuning Loops” (if at least one loop has been selected)

and then show a test screen. As data is collected, the count for each lane entered will be shown. Note that the Phoenix

II is not collecting and storing data at this point – it is testing the lanes for proper setup. Press ENTER to continue. The

system will now ask the final start questions.