Instruction manual

Copyright ©2006 Diamond Traffic Products
ALL RIGHTS RESERVED
45
Leave this at No by pressing ENTER.
Leave this at No by pressing ENTER.
Leave this at No by pressing ENTER.
Leave this at No by pressing ENTER.
Select the Record Interval length; this should remain at 00:15, so press ENTER.
At this point, the next vehicle to cross the Axle Sensors will show as a test
vehicle. The first vehicle to cross in lane # 1 will show something like below.
The asterisk (*) means no data is being stored yet. Wait for vehicles in both lanes
two pass, and if data is correct, press ENTER.
Since we want to start collecting right now, press ENTER.
Since we are running a test file, press ENTER.
Press the ENTER key. The counter is now collecting data as vehicles pass. The
display should be blank.
DO NOT TURN OFF THE UNIT!
Binned Data collection has started. After a few record intervals have passed you may want to try the Stop Collection
Example (5.g) and then retrieve the data following the instructions in the Centurion Software Help Menu.