Instruction manual

Since we have set our road tubes for lane subtraction, change this to Subtraction

with the arrow keys and press ENTER.

To change selection use the arrow keys, using No as default.

Press ENTER when done.

Use the keypad to enter the direction or some other piece of information about the

lane, for example: Westbound.

Press ENTER when done.

Choose the sensor type to be used, Choose Axle for Road Tube setup.

Press ENTER when done.

To change selection use the arrow keys, using No as default.

Press ENTER when done.

Change this interval length to 1 hour by pressing 0,1,0,0.

Press ENTER when done.

At this point, the next vehicle to cross the road tube will show as a test vehicle.

The first vehicle to cross in the eastbound lane will show:

Press ENTER when done.

Since we want to start collecting right now, press ENTER.

Since we are running a test file, press ENTER.

Press the ENTER key. The counter is now collecting data as vehicles pass. The

display will turn its self off.

DO NOT power off the unit!

Count data collection has started. Note that the counter will not actually begin storing record intervals until the beginning

of the next record period. In this example, the next even hour is (16:00:00). After a few record intervals have passed

you may want to try the Stop Collection Example (5.g) and then retrieve the data following the instructions in the

Centurion Software Help Menu.