Specifications

DISSOLVE AND FORCE EFFECTS
Dissolve and Force
84 Operation Edition 1.08 CXPS Manual
• DIS <output #>
Where:
<Output #> is identical to the output number specified in setup.
•When dissolving, issue this command again to dissolve from <from source>
back to <output #>
•When forcing, issuing this command again will produce no effect.
See Figure 21 on page 82 for an example of the Force effect.
• DIS <output #> <delay rate>
Where:
<output #> is identical to the output number specified in setup.
<delay rate> is the number of frames (1-1024) for the delay.
EXAMPLE:
In Dissolve Setup (Step 1), you set up a dissolve effect to dissolve Window 5 to
reveal its background on Output display 7. You would like Window 5 to dissolve
away, and after a delay of 60 frames, dissolve back into view. The command
initiate the effect is:
DIS 7 60
The Dissolve FlipFlop Command
The DISFF Command can be used to dissolve (not force) between two output channels that
are not under windowing mode. The full effect of this command will not be visible unless
display screens are connected to both channels in the dissolve pair.
When the DISFF command is issued, the video from one display screen (Display screen A)
will be gradually replaced by that from another display screen (Display Screen B). Once the
dissolve is complete, the video that had appeared on Display screen A before the dissolve
will be immediately switched to fill Display screen B.
DISFF <output #>
Where:
<output #> is identical to the output number specified in setup.
NOTE:
The delay rate feature can only be used when dissolving from a window
to its background.