Owner`s manual

1190 Series Owner’s Manual

1190Rb Assembly Instructions (continued)

mast cover all the way to the top. Then hold the bottom of the console mast

next to the console mast receptor and point the top of the console mast

downward.

3. Install the console mast by sliding it into the console mast receptor while

pulling the wire harness. Insert and tighten four M8x55mm Bolts using an

Allen wrench.

4. Place console mast cover in place and align it with screw holes. Insert and

tighten four M5x12mm screws and washers using a Phillips screwdriver.

Step 4: Console Assembly

1. Connect the three plugs, from main wire harness Up/Down keys on the

handle bars and hand pulse harness, to the plug receptors on the backside of

the console, taking care to install correctly (see plug alignment marks).

WIRING HARNESS INSTALLATION HINT: Any excess wiring must be carefully

inserted (“stored”) back into the console mast before installing the console

onto the console mounting plate.

2. Fasten the console to the console mounting plate with the four M5x12mm

screws and washers using a Philips screwdriver.

Step 5: Handlebar Assembly

1. Place the handlebar onto the mount and insert and tighten two M8x20mm

screws using an Allen wrench. Note: The handlebar can be installed upside

down. When installed properly, the hand grips will be on the sides of the

console.

Step 6: Pedals

1. Using a 15mm open-end wrench to firmly affix the pedals to the cranks. The

pedals should be tightened as much as possible to prevent the pedals from

becoming loose. The pedals should also be checked after 8 hours of use to

ensure they are affixed properly as they can loosen after use.

2. The left and right pedals are different and are denoted as right or left on the

bottom of each pedal. NOTE: Left pedal threads counter-clockwise.

Step 7: Water Bottle

1. Place the bottle holder on the console mast. Insert and tighten the two

M5x12mm screws using a Phillips screwdriver.

2. Snap the water bottle into the holder.

Step 8: Leveling Pad

1. Adjust all three leveling pads, located on the bottom of the stabilizer bar

and the main frame, to ensure your equipment is leveled with floor.

1190seriesOM 5/21/08 2:31 PM Page 11