Installation Guide

INSTALLATION GUIDE
CVR-8
HD SE
Important installation information
IMPORTANT!
Keep an eye out for these icons:
Normal install time
60 minutes
Tips to assist installation
Helpful Hints
Identify which track system your RAMBOX system uses. If you have
the silver track, please proceed to step 2 of this guide. If you have
the black track, skip to attached guide CVR-8b which is specific to
that system.
1
Remove the adhesive backing from the underside of the square-tube
shims before affixing a square-tube shim to the top of each track,
ensuring that...
3
Clean the top of the utility tracks thoroughly with a clean, lint-free cloth
and rubbing alcohol or glass cleaner. Allow to dry.
2
CONTINUED ON NEXT PAGE >
DiamondBackCovers.com / 800 935 4002
Ram Trucks with RamBox Cargo
Management System
Square-Tube
Shims (2)
No-Top-Jaw
Clamps (4)
Gas
Springs (4)
Clean, Lint-
Free Cloth
Rubbing Alcohol
or Glass Cleaner
TOOLS REQUIRED:
PARTS INCLUDED:
× 4
Ratchet Wrench,
(Torque Wrench
preferred)
9/16 Wrench
7/ 16"
Socket
9/16"
Socket
IDENTIFY & PREPARE THE CARGO BED
weather
strip
silver track
adhesive
bed
wall
shim
OR
silver track
black
track
The forward end is tight
against the bulkhead.
The weatherstripped
side of shim is tight
against the bed wall.
The adhesive strip faces
down onto the top of the
silver track.
A
B
C
MOUNT THE PANELS
1/8" Hex
Key
4 6
Each panel is tapered front to
back. Make sure the arrow on the
underside of the panel is pointed
toward the tailgate.
Place the center panel across the bed
cheated toward the tailgate.
Position the cover front to back so that
the front of the cab panel lines up with
the outside edge of the center of the
bulkhead. Center the cover side-to-side
on the truck.
5
CAUTION! Be sure all hinges are
fully mated before lowering panels.
Attach the tail panel by holding it at a 90°
angle from the bed rails and mate the driver's
side hinge first, followed by the passenger
side's c-shaped hinge.
90°
MATE
FIRST
MATE
SECOND
PRE-INSTALLATION NOTES
(REVIEW ALL OTHER INCLUDED INSTALLATION GUIDES BEFORE BEGINNING)
If you're installing a rear window protection accessory,
mount it prior to mounting the cover.
Some models require bulkhead preparation first. Please refer to the instructions in
the bulkhead prep kit prior to mounting the cover.