Instructions

www.diclaadsystemen.nl
20
NL
DE
EN
NL
DE
EN
LED will light up again. The connector remains locked until the plug is removed
from the vehicle.
Stop charging by removing the connector from your vehicle, the charger auto-
matically stops the charging session.
Start loading: RFID card/key-Tag system
With an RFID system, the charger starts/stops after you have shown your corres-
ponding DIC card or key tag to the card reader. In the case of an RFID card system
without settlement, the charging cards supplied with the card are pre-coupled.
Remote pairing is not possible.
First connect your vehicle to the charging station and then scan your charging card or
key fob. After scanning, the charging station checks the correct connection, after a
missed check the charger starts, the plug is locked and the blue LED “Charge” lights up.
Attention! When the battery is fully charged, the charger automatically stops
charging, the green “Power” LED will light up again. The connector remains locked
until the same charging card or key tag is offered again.
Stopping charging
Offer the same charging card or key tag that you also used to start charging.
After submission, the green LED will light up and the plug will be unlocked.
6 ASSIGNING ADDITIONAL CHARGING CARD
Offer the Master card, then offer the new charging card. Then offer the Master
card again. The new card is now ready for use.
7 MAINTENANCE
Make a good plan to carry out periodic maintenance. Preferably at least once a year.
Maintenance to the charging point may only be carried out by an authorised person
in accordance with NEN 3140 and NEN 50110.