User's Manual
Table Of Contents
- 1 Manufacturer´s Certification
- 2 Supplier’s Declaration of Conformity
- 3 Introduction
- 4 Basic settings
- 5 Setting Up the Device
- 6 Overview
- 7 Projected Capacitive Touch Screen
- 8 Planning the Installation
- 9 Installation to a stand
- 10 Connector Panel
- 11 Storage Media
- 12 Installing System to a Wall
- 13 Mounting a Second Display (A1150/D1101)
- 14 Peripherals (optional)
- 15 Starting Up the System
- 16 Error Reporting
- 17 POST Code
- 18 Technical Data
- 19 Appendix
9
9 Installation to a stand
Take the stand and the monitor out of the packaging. For installation you will need a Torx screwdriver to
loosen and tighten the Torx screws.
9.1
9.1 Installing system to the stand (standard)
9.1.1
9.1.1 Preparing the stand
1
1. Remove the VESA cover by sliding it down-
wards (indicated by arrow).
NOTE
*Observe the safety precaution mentioned on the next page when you remove the back
cover of stand.
WARNING
To avoid damage to the back cover of the stand, be careful of how you would remove it.
Copyright © 2020, Diebold Nixdorf
01750342843B
9-1