User's Manual
Table Of Contents
- 1 Manufacturer´s Certification
- 2 Supplier’s Declaration of Conformity
- 3 Introduction
- 4 Basic settings
- 5 Setting Up the Device
- 6 Overview
- 7 Projected Capacitive Touch Screen
- 8 Planning the Installation
- 9 Installation to a stand
- 10 Connector Panel
- 11 Storage Media
- 12 Installing System to a Wall
- 13 Mounting a Second Display (A1150/D1101)
- 14 Peripherals (optional)
- 15 Starting Up the System
- 16 Error Reporting
- 17 POST Code
- 18 Technical Data
- 19 Appendix
Installation to a stand
9.3.2
9.3.2 Preparing the system
1 1
1
1
1. Place a piece of protection sheet on a flat
surface e.g. a table.
2. Lay the display face down on the protection
sheet.
3. Remove the 4 screws (1) that come with the
Beetle A Series.
9.3.3
9.3.3 Installing system to the stand
1. Fit the system on the stand while holding it in
place.
1
1
1
1
2. Tighten the 4 M4x6 countersunk screws (1)
(that came with the stand) to secure the sys-
tem to the stand.
Copyright © 2020, Diebold Nixdorf
01750342843B
9-11