User's Manual
Table Of Contents
- 1 Manufacturer´s Certification
- 2 Supplier’s Declaration of Conformity
- 3 Introduction
- 4 Basic settings
- 5 Setting Up the Device
- 6 Overview
- 7 Projected Capacitive Touch Screen
- 8 Planning the Installation
- 9 Installation to a stand
- 10 Connector Panel
- 11 Storage Media
- 12 Installing System to a Wall
- 13 Mounting a Second Display (A1150/D1101)
- 14 Peripherals (optional)
- 15 Starting Up the System
- 16 Error Reporting
- 17 POST Code
- 18 Technical Data
- 19 Appendix
11
11 Storage Media
Mass storage in the Beetle A Series is a double-slot Socket 3 (M-Key) for Type 2280 M.2 SSD card.
• Solid State Disk (SSD)
A solid state disk is a data storage drive that uses memory elements in place of a rotating disk to store
data. The SSD easily substitutes the hard disk and emulates a hard disk drive interface. Most SSDs are
flash memory-based.
11.1
11.1 Replacement of Solid State Disk
1. First, ensure that the device is switched off and the power connector is disconnected.
Figure11-1: Removing the cable connection cover
2. Remove the display from the stand, and lay
it on a flat surface.
3. Remove the cable connection cover at posi-
tion (1) by pulling it downwards (see arrow)
to uncover the connector panel.
4. Detach all connectors from the connector
panel.
Figure11-2: Releasing the back cover
5. Lift up and turn the 2 knobs (1) counter-
clockwise to release the back cover (2) from
the display by pulling it downwards.
CAUTION
Risk of damage to cables
Presence of cables connecting the con-
troller module to the display module.
Due to limited length of the connecting ca-
bles, care must be taken when removing
the controller module from the display
module to avoid damaging these cables.
Copyright © 2020, Diebold Nixdorf
01750342843B
11-1