Operating Instructions

2020
Do not dismantle, modify or otherwise alter the operation of this product in any manner. Do not operate this product in an unlawful or
illegal manner or as to jeopardize the safety of the operator or others.
When the battery is fully charged, please remove the USB charger lead promptly
Precautions Of Li-Po Batteries
INDICATOR LIGHT STATUS AT THE TIME OF CHARGING:
Safe Usage Instructions for Li-Po Batteries
IMPROPER USE OF THIS PRODUCT
WARNING
IMPORTANT NOTICES
1. Battery can be charged only by originally configured USB charger lead.
2. Be sure to charge with the white Big socket port, not the yellow socket.
3. 7.4V 600mAh Li-Po must be equipped with 5V USB charging plug.
4. Any Li-Po battery with a damaged appearance should NOT be charged to
avoid fire hazards from spontaneous combustion.
5. The battery should be charged according to the specified charging time period.
• Li-Po batteries pose a higher danger compared with other batteries.
• This company does not bear any responsibility resulting from improper usage.
• DO NOT attempt to charge the Li-Po battery with any charger other than the
included original charger. Failure to do so may result in an explosion or fire. DO
NOT dismantle, subject to impact, incinerate or reverse the connections of the
battery. Avoid metal objects impacting the positive and negative polarities of the
battery. Please prevent sharp objects from penetrating the battery to avoid the
potential of fire.
• Please use caution when charging the battery and ensure charging occurs in a
visible area. DO NOT leave battery unattended while charging.
• Battery should be kept out of reach of children to avoid any injury.
• A degraded battery should not be attempted to be recharged. Battery
expansion, deformation, explosion or fire may occur.
• Degraded batteries should be disposed of properly following regional or national
disposal guidelines to ensure protection of the environment.
Uncharged state:
This product contains small parts and is not intended for children under the age of 8.
The remote control requires 2 X 1.5V AAA non-rechargeable batteries and the RC model requires a 7.4 V 600mAh Li-Po battery (included)
The RC model motor can generate heat and should not be touched to avoid possible burns.
Periodically check the wire, plug, shell and other parts of the charger for wear or damage and discontinue use if detected until
repaired or replaced.
The RC model should only be charged using the recommended guidelines.
The LEDs (Light Emitting Diodes) can emit radiation and should not be pointed directly at the eyes.
Aviation restrictions forbid the use of Radio Control devices within a radius of 3 miles or 5000 meters from any airport runway or facility.
Truck, Controller,
USB charger with cable,
Two AAA batteries, Lithium battery,
Window box package
red light always lit
Full charging state:
Red and green
light always lit
Charged state:
Red light always lit
& Green light flashes
Track Movements
Boom Movements
Bucket Movements
Swing
Movements
Stick Movements
Lights and Sound
Stick and Swing
Movements
Lights
and Sound
Track Movements
Power OFF / ON
Boom and Bucket Movements
Auto / Demo Function
AUTO / DEMO FUNCTION
25M
0.4 km/h
50 - 65 min.
AAA size x 2
120 min.
1x7.4V 600mAh
1:24
1462gProduct Weight (Bucket, exclude battery)
max. 0.2 kg / 0.5 lbsBucket Loading
2020
8+
Diecast Masters scale models are adult collectibles,
not toys. Not intended for children under 8.
Bucket, stick, boom and
model driving control for
approximate 1-2 minutes.
Intelligent USB balance charger with
overcharge prtection
Input: 5.0V 1-2A
Data change in Battery/USB
PARAMETERS:
Output: DC 4.2V, 800mA
Battery specifications:
18650
7.4V 600mAh Li-Po
BATTERY / USB PARAMETERS
7.4V 600mAh Li-Po (Enclosed)
336 Hydraulic Excavator
OPERATING INSTRUCTIONS
336 Hydraulic Excavator
OPERATING INSTRUCTIONS
25001
1:24
SCALE
FCC STATEMENT
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may
not cause harmful interference, and 2) this device must accept any interference received, including interference that may
may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to
operate the equipment.
IMPORTANT NOTICES
The device has been evaluated to meet general RF exposure requirement, the device can be used in portable exposure
condition without restriction.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.