Specifications

105
7.3.3 Push-Pull couplings connection on the
boom head
To connect the Push-Pull quick couplings to the sockets
positioned on the boom head:
1. Perform the equipment installation procedures
described in the “Equipment installation procedure”
chapter:
2. Switch the vehicle off
3. In the event of closed-centre distributor, discharge the
residual pressure from the plant as described previously.
4. Remove the protection hood from the equipment
hydraulic plugs (Fig. 3-I0200).
5. Lift the hydraulic socket protective cover on the boom
head (Fig. 4-I0200).
6. Remove any dirt from the plug and socket.
7. Insert the plug into the socket and press to block the
hose (Fig. 5-I0200).
8. Check that the hydraulic hose is fi xed correctly.
9. Carry out the same operations for both hoses.
Consult the equipment manual to check the
correct operation of the same.
3- I0200
4- I0200
5- I0200