Specifications

Notes Stamp and signature
Controls Notes
Mandatory controls that must be made every 250 hours or every 2
months
Control of the machine / equipment for the presence and state of preservation safety
Decals
o
Control of the machine \ equipment for the presence and state of preservation of
Bearing capacity diagrams
o
Control of the machine \ equipment for the presence and state of preservation of Use
and maintenance manual
o
Control of the machine \ equipment for the presence and state of preservation of
Nameplates
o
Spirit level calibration (if present) o
Checking the compliance of machine operating mode with the equipment installed o
Checking the operation of the emergency push-buttons o
Mandatory controls that must be made every 400 hours or every 3
months
Hooking points, wear condition and adjustment of chains (if present) o o o
Maximum hydraulic plant pressure (if present) o
2 / 2