Manual

Tap the other axle cap onto the opposite end of

the axle and place the axle assembly onto the

bottom of the charger. Place one end of the

bracket into slot, then place the axle assembly

under each bracket. Fasten the other side of the

brackets using the two 10-32 screws provided.

To attach the handle:

Turn the charger right side up onto itsfoot and wheels.

Remove the two top screws from each side of the

charger and align with the screw holes on the handle.

Attach the handle using the same screws.

Plugging it in

Your charger should be grounded to reduce the

risk of electrical shock.

Your charger isequipped with an electrical cord that

has an equipment grounding conductor and a ground-

ing plug designed to be used on a 120 volt circuit. The

plug must be plugged into an outlet that has been

properly installed and grounded in accordance with all

local codes and ordinances.