Operator`s manual

• 10 •
Amp/Volt Selector Switch10.1
2A, 12V
AMP/VOLT
SELECTOR
4A, 6V
LED Display10.2
CHECK BATTERY (red) LED lit: Indicates the battery is not properly
connected to the charger.
CHECK BATTERY (red) LED blinking: Indicates the charger is in
abort mode.
CHARGING (yellow) LED lit: Indicates the charger is charging
the battery.
CHARGED (green) LED lit: Indicates the battery is fully charged and
the charger is in maintain mode.
NOTE: See the Operating Instructions section for a complete
description of the charger modes.
OPERATING INSTRUCTIONS11.
This battery charger must be properly assembled in
accordance with the assembly instructions before it is used.
The charger does not have an On/Off switch. Plug the 71219 into
a 120V AC electrical wall outlet only after battery connections have
been made and the Amp/Volt selector switch has been set.
NOTE: This charger is equipped with an auto-start feature. It will not
supply current to the battery clips until a battery is properly connected.
Meaning, the clips will not spark if touched together.
Charging
Ensure that all of the charger components are in place and in 1.
good working condition, for example, the plastic boots on the
battery clips.
Connect the battery following the connection instructions 2.
described in Using the Quick-Disconnect Cable
Connectors section.