Operator`s manual

• 15 •
MOVING AND STORAGE INSTRUCTIONS14.
Store the charger unplugged, in an upright condition. The AC cord 14.1
will still conduct electricity until it is unplugged from the outlet.
Store inside, in a dry, cool place.14.2
Do not store the clips on or around metal, clipped together or 14.3
clipped to cables.
If the charger is moved around the shop or transported to 14.4
another location, take care to avoid/prevent damage to the
cords, clips and charger. Failure to do so could result in personal
injury or property damage.
TROUBLESHOOTING15.
PROBLEM POSSIBLE CAUSE REASON/SOLUTION
Charger will
not turn on
when properly
connected, and
no LEDs are lit.
AC outlet is dead.
Poor electrical
connection.
Check for an open
fuse or circuit breaker
supplying the AC outlet.
Check the power cord
and extension cord for a
loose tting plug.
CHECK
BATTERY (red)
LED is lit.
Reverse connections at
battery.
Battery voltage is too low.
Battery is not properly
connected to the
charger.
Unplug the charger
and correct the lead
connections.
This charger has an
automatic start feature.
If the battery voltage
is under 0.2 Volts, the
charger will not detect
it and will not start the
charging process. Have
the battery checked/
replaced.
Make sure the
connections from the
battery connector cable
to the battery and to the
charger are tight.