Operator`s manual

• 8 •
When disconnecting the charger, turn all switches to off (if 6.8
applicable), disconnect the AC cord, remove the clip from the
vehicle chassis and then remove the clip from the
battery terminal.
See CALCULATING CHARGE TIME for length of 6.9
charge information.
FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE 7.
VEHICLE.
A SPARK NEAR THE
BATTERY MAY CAUSE A
BATTERY EXPLOSION. TO
REDUCE THE RISK OF A
SPARK NEAR THE BATTERY:
Check the polarity of the 7.1
battery posts. The POSITIVE
(POS, P, +) battery post usually
has a larger diameter than the
NEGATIVE (NEG, N, -) post.
Attach at least a 24-inch (61 7.2
cm) long 6-gauge (AWG)
insulated battery cable to the NEGATIVE (NEG, N, -) battery post.
Connect the POSITIVE (RED) charger clip to the POSITIVE 7.3
(POS, P, +) post of the battery.
Position yourself and the free end of the cable you previously 7.4
attached to the NEGATIVE (NEG, N, -) battery post as far away
from the battery as possible – then connect the NEGATIVE
(BLACK) charger clip to the free end of the cable.
Do not face the battery when making the nal connection.7.5
Connect charger AC supply cord to electrical outlet.7.6
When disconnecting the charger, always do so in the reverse 7.7
order of the connecting procedure and break the rst connection
while as far away from the battery as practical.
A marine (boat) battery must be removed and charged on shore. 7.8
To charge it onboard requires equipment specially designed for
marine use.