OPERATOR'S MANUAL ® Portable Power 950 Jump Starter and DC Power Source Model No. 200.71987 CAUTION: Read all Safety Rules and Operating Instructions, and follow them with each use of this product. Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
SECTION PAGE 1. IMPORTANT SAFETY INSTRUCTIONS 1 2. PRODUCT FEATURES 2 3. CHARGING THE INTERNAL BATTERY 2 4. JUMP-STARTING 3 5. DIGITAL DISPLAY FUNCTIONS 4 6. POWERING A 12V DEVICE 4 7. USING THE USB PORT 5 8. USING THE BUILT-IN LIGHT 5 9. INTERNAL BATTERY REPLACEMENT 5 AVEHICLE ENGINE I0.STORAGE AND MAINTENANCE 6 11. SPECIFICATIONS 7 12.
iMPORTANT: CHARGE iMMEDiATELY AFTER PURCHASE IMPORTANT: READ AND SAVE THIS SAFETY AND INSTRUCTION MANUAL. 1.1 Charge the 950 internal battery immediately upon purchase, every 30 days and after every use. 1.2 Use in a welt ventilated space. 1.3 Contains a sealed, non-spitlable lead-acid battery. Must be disposed of properly. 1.4 WARNING: Possible explosion hazard. Contact with battery acid may cause severe burns and blindness. Keep out of reach of children. 1.
5 1. JUMP START ON/OFF Switch. Turn on to activate clamps and USB. 2. 3. Digital Display percentage of charge Plastic lens cover 4. Two, Light bulbs 5. Two, 12V DC power outlets 6. Rear charger plug (not shown) 7. 8. Clamps and Cables USB Port 9. Power Switch (LIGHTS, OFF, and DISPLAY). This power switch turns on the light or the internal battery status digital display. 10. Wal! charger IM PORTANT: '_CHARGE iMMEDiATELY AFTER PURCHASE '_KEEP FULLY CHARGED.
3.1 Check theinternal battery's charge levelbypressing theswitchmarked DISPLAY. TheDigital Display wiltshowthebattery's percentage. Charge if under100% NOTE: Internal battery's percentage is mostaccurate whenthePortable Power 950hasbeendisconnected fromalldevices andcharging sources for1-24hours. 3.2 Tocharge, plugthe(external) wallcharger cordintothesocket onthe backofthe950.Then,plugthewallcharger intoa 120VAC source.
CAUTION: Ifyouhaveconnected theclamps backwards, anaudioalarm willsound. DONOTturntheON/OFF switchtotheONposition. Thiscould causeserious damage. Reverse theconnections andtheaudioalarmwilt stop. 4.5 TurnONtheJUMPSTART ON/OFF switchandthenturnkeyandcrank theengine. Iftheengine doesnotstartwithin5-8seconds, stopcranking andwaitatleast1 minute before attempting tostartvehicle again.This permits thebattery tocooldown. 4.6 Aftertheengine starts,makesuretoturnOFFtheJumpStartswitch.
12V DC Electrical Device Appliance Type Fluorescent Lights, Cellular Radios, Electrical Electric Phones Fans DVD Players, Spotlights Tools, Bilge Pumps Coolers Air Compressors, Chart Estimated Depth Finders, Camcorders, Run=Time Car Vacuums Power Estimated Time* 4 Watts 40 Hours 9 Watts 21 Hours 15 Watts 12 Hours 24 Watts 7 Hours 48 Watts 3 Hours 80 Watts 1.5 Hour *NOTE: Estimated run-times. Actual time may vary.
9.5 Remove the negative (first) and positive nuts and bolts securing the cable to the battery. 9.6 Push cables to the side and carefully slide battery out of the 950. 9.7 Reverse steps for assembly. Make sure that the nuts and bolts securing the cables are tight. IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE KEEP FULLY CHARGED. Charge the 950 internal battery immediately upon purchase, every 30 days and after every use. All batteries are affected by temperature.
Internal Battery Type DieHard Maintenance-free Nominal Voltage 12v DC Capacity AGM Lead-acid 18 Ah DC Power Outlet (Max. Continuous Load) 15A With Automatic Circuit Breaker Reset Built-in Light Bulb (Replaceable) 5w/12v DC (Base type BA9S) Jumper Cables 4-gauge AWG, 24 Inches Dimensions (H xW x D) 12 H x 11 x 10.5 Inches Product Weight 18.9 Lbs. Parts and customer technical assistance is available Monday-Friday, to 4:30 pm Central Time at 1-800-SEARS-64.