Warranty

To instantly water push
Push to stop or it will run for the programmed time (if set).
Default watering time is 5 minutes.
Maximum operating pressure: 80 PSI • For irrigation use only
Used to shut-down timer in winter or when it is raining. Set
schedules will be retained. You must turn this feature off to
resume programmed watering schedules.
Push and hold for 3 seconds until the symbol appears
on the display.
Push and hold for 3 seconds and the symbol will
disappear and the previously programmed watering schedules
will resume.
SETTING - START TIMES
D
MANUAL OPERATION
E
DELAY WATERING
F
Push and select Starts (start time).
Adjust hours using or push to adjust minutes.
You can set up to 4 start times.
To stop
manual run
or scheduled
watering
Cycle through
programming modes
Lowers the value of the
flashing selection
Raises the value of the
flashing selection
Selects a value
to adjust
For instant
watering
9V ALKALINE BATTERIES ARE RECOMMENDED
• Remove the battery cover - keep battery compartment dry - install the 9V
battery by lining up the connections.
• Place the battery inside the compartment and reinstall the battery cover.
NOTE: When battery is first connected, it takes up to 1 minute for the
battery indicator to assess the battery strength.
• Remove and clean the screen washer on inlet side of the timer
every few months.
• Remove battery if timer is not used for an extended time.
• In freezing conditions, un-install the timer and bring it indoors
to prevent damage.
INSTALLING THE BATTERY
DIGITAL HOSE END TIMER
CONTROL BUTTONS
MAINTENANCE
I N S T R U C T I O N M A N U A L
3 year warranty
BO9D, BO9DB
1210 Activity Drive
Vista, CA 92081-8510, USA
800-344-2281 • 760-727-0914
www.digcorp.com
e-mail: [e-mail]
26-041 REV B
Attach the timer inlet to
the outdoor faucet/spigot
turning clockwise - hand
tighten only. From the
timer outlet connect a
drip irrigation system or
a garden hose.
Set the current day
Push until the square
flashes under the day of the week.
Set the day of the week using
SETTING - TIME & DAY
A
Set the current time
Push to select hours then
again to set minutes.
Adjust using
AM/PM is set by increasing or
decreasing the hour.
Push and select Duration.
Adjust hours using or push to adjust minutes.
SETTING - WATERING DURATION
B
Push and select Days.
Push until the square flashes under Monday.
Push to deactivate Monday or to keep it active and
advance to Tuesday. Do this for each day you would like to water.
SETTING - WATERING DAY(S)
C
HOW TO INSTALL
Timer inlet:
3/4 in. female
hose thread
with screen
washer
Timer outlet:
3/4 in. male
hose thread