Installation Guide

INSTALLING THE BATTERY
BLUETOOTH
®
HOSE END TIMER
COMPONENT IDENTIFICATION
MAINTENANCE
INSTRUCTION MANUAL
3
-
year warranty
BOHE
-
BT
1210 Activity Drive
Vista, CA 92081-8510
760.727.0914
www.digcorp.com
e-mail: [e-mail]
26-303 REV A English
SCANNING SCREEN
HOW TO INSTALL
Operating pressure: 10-120 PSI • For irrigation use only
Flow rate: 3.8-14 GPM • IP64 Certified
Battery
compartment
cap
Timer inlet,
3/4′′ female hose thread
One button
for manual
run and reset
Timer outlet,
3/4′′ male hose
thread
Two AA alkaline batteries are recommended
• Remove the battery cover - keep the battery compartment dry -
install two AA batteries (See orientation).
• Place the battery inside the compartment and reinstall the battery cover.
• Remove and clean the screen washer on the inlet side of the timer
every few months.
• Remove the batteries if the timer is not used for an extended time.
• In freezing conditions, uninstall the timer and bring it indoors to
prevent damage.
Attach the timer inlet to
the outdoor faucet/spigot,
turning clockwise - hand
tighten only. Connect a
drip irrigation system
or a garden hose to the
timer outlet.
Timer inlet:
3/4″ female
hose thread
with screen
washer
Timer outlet:
3/4″ male
hose thread
HOME SCREEN
C
SETTINGS SCREEN
MANUAL RUN SCREEN
The timer can also manually run from the timer itself by
tapping the water droplet button . The duration of this
manual run is equal to the duration of the scheduled program.
The button can also be used to end any watering.
The timer’s Settings
screen contains
everything else needed
to fully control your
irrigation system. It can
be reached by selecting
the Controller Settings
button on the
bottom of the screen.
The Manual Run screen
allows for manual
operation of the timer.
It can be reached by
selecting the Manual
Run button on the
bottom right of the
screen. Modify the dura-
tion by tapping on it and
start and end the run by
tapping the button to
the right.
Tap on the screen to connect
to your timer.
New controllers appear as
"BT Hose End Timer".
You can access Connection
History and Contact Us
through the information
icon in the top right
corner of the screen.
Once connected, the Home
screen will appear. On this
screen, you can program the
schedule using days of the
week, even/odd, or every x
days and then proceed to
the start times and duration.
The schedule overview
will update instantly with
everything you program.
D
E
B
DOWNLOAD DIG BTT APP
A
FCC certied, CE Bluetooth® Compliance