User's Manual
Table Of Contents
- About the Modules
- What’s on the Module?
- About the Development Board
- Basic description
- Switches and buttons
- I2C and SPI header connectors
- Serial port connectors
- VGA connector / External LCD clock
- Development board SO-DIMM connector, P15
- Application-specific expansion headers - P16 and P17
- LCD application board header, P18
- USB Device application header, P32
- Digital I/O, P19
- Power over Ethernet (PoE) connectors
- Through-hole prototyping (wrap-field) area, P3 and P4
- Development board LEDs
- Current Measurement Option (CMO)
- Power jack, P12
- Test points
- Factory default interface configuration for development board
- LCD and USB Configuration
- Module Specifications
- Mechanical dimensions
- Environmental information
- Network interface
- Power requirements
- Real-time clock
- I2C signals
- USB interface
- Module reset
- Module / SO-DIMM signal characteristics
- Electrical characteristics
- DC electrical characteristics
- USB internal PHY DC electrical inputs and outputs
- Antenna information
- Antenna specifications - 2 dBi Dipole
- Antenna specifications - 5 dBi Dipole
- Antenna specifications - 2 dBi PCB mount
- FCC RF radiation exposure statement
- Safety statements
- Dimensions and PCB Layouts
- Certifications
Index-4 ConnectCore 9C/Wi-9C Hardware Reference, Rev B 01/2007
Index
ConnectCore 9C 67
ConnectCore Wi-9C 67
power switch, SW5 32
power up 67
pushbuttons (user) 29
R
real-time clock 67
recommended operating conditions 75
RF exposure statement 84
RP-SMA connectors 27
primary, P10 27
secondary, P8 27
S
safety statements 84
sample applications (LCD) 61
serial LEDs 54
serial port A (EIA-232/422/485) interface 35
serial port A connector 35
Serial Port A switch, SW1 31
serial port B (EIA-232) interface 36
serial port B connector 36
Serial Port B switch, SW2 32
serial port C connector 37
serial port C interface 37
serial port connectors 35
-
38
serial port D connector 37
serial port D interface 37
serial port interface 4
serial ports 29
SO-DIMM connector, P15 40
-
42
inserting 41
pin assignment 42
pin orientation 43
SPI header connector 34
SPI interface 29
SW1, Serial Port A switch 31
SW2, Serial Port B switch 32
SW3, USER_PUSH_BUTTON_1 32
SW4, USER_PUSH_BUTTON_2 32
SW5, power switch 32
SW6, hardware reset switch 32
SW7, VGA (enable) switch 32
switches
SW1, Serial Port A
31
SW2, Serial Port B 32
SW3 and SW4, user-programmable
pushbuttons
32
SW5, power 32
SW6, hardware reset 32
SW7, VGA (enable) 32
switches and buttons 31
system clocks 2
T
test points 29, 57
through-hole prototyping (wrap-field) area, P3
and P4
52
through-hole signal rail, P3 52
U
U.FL connectors 27
primary, P11 27
secondary, P9 27
USB configuration 63
USB Device application header, P32 48
USB Host and Device interface 3
USB Host connector, P6 (module) 18
USB interface 68
-
69
no USB on module 68
USB Device only 69
USB Host with hub on module 68
USB Host/Device 68
USB internal PHY DC electrical
characteristics
77
user LEDs 54
user pushbuttons 32
V
VGA (enable) switch, SW7 32
VGA connector, P6 (dev board) 39
VGA interface 29