User's Manual
Table Of Contents
- About the Modules
- What’s on the Module?
- About the Development Board
- Basic description
- Switches and buttons
- I2C and SPI header connectors
- Serial port connectors
- VGA connector / External LCD clock
- Development board SO-DIMM connector, P15
- Application-specific expansion headers - P16 and P17
- LCD application board header, P18
- USB Device application header, P32
- Digital I/O, P19
- Power over Ethernet (PoE) connectors
- Through-hole prototyping (wrap-field) area, P3 and P4
- Development board LEDs
- Current Measurement Option (CMO)
- Power jack, P12
- Test points
- Factory default interface configuration for development board
- LCD and USB Configuration
- Module Specifications
- Mechanical dimensions
- Environmental information
- Network interface
- Power requirements
- Real-time clock
- I2C signals
- USB interface
- Module reset
- Module / SO-DIMM signal characteristics
- Electrical characteristics
- DC electrical characteristics
- USB internal PHY DC electrical inputs and outputs
- Antenna information
- Antenna specifications - 2 dBi Dipole
- Antenna specifications - 5 dBi Dipole
- Antenna specifications - 2 dBi PCB mount
- FCC RF radiation exposure statement
- Safety statements
- Dimensions and PCB Layouts
- Certifications
. . . . .
MODULE SPECIFICATIONS
USB internal PHY DC electrical inputs and outputs
www.digiembedded.com 77
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
USB internal PHY DC electrical inputs and outputs
The USB internal PHY DC electrical inputs and outputs are used only when there is
no USB configuration on the module.
USB internal PHY
DC electrical
inputs
Notes:
1 |(usb_dp) – (usb_dm)|
2 Includes V
DI
range.
USB internal PHY
DC electrical
outputs
Notes:
1 Measured with R
L
of 1.425k ohm to 3.6V.
2 Measured with R
L
of 14.25k ohm to GND.
3 Excluding the first transition from the idle state.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Antenna information
The ConnectCore Wi-9C module provides use of one of these antenna types:
2 dBi Dipole
5 dBi Dipole
2 dBi PCB mount
Be sure that your antenna choice complies with the regulatory requirements of your
region. In North America, for example, you can operate only with antennas
Symbol Parameter Min Max Units Notes
V
IH
Input high level (driven) 2.0 V
V
IZ
Input high level (floating) 2.7 3.6 V
V
IL
Input low level 0.8 V
V
DI
Differential input sensitivity 0.2 V 1
V
CM
Differential common mode range 0.8 2.5 V 2
Symbol Parameter Min Max Units Notes
V
OL
Output low level 0.0 0.3 V 1
V
OH
Output high level 2.8 3.6 V 2
V
CRS
Output signal crossover voltage 1.3 2.0 V 3