User's Manual

. . . . .
ABOUT THE DEVELOPMENT BOARD
Connect Wi-Wave module connector, P52
www.digiembedded.com 17
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Connect Wi-Wave module connector, P52
Place the Connect Wi-Wave module into the connector and support bracket, P52, on
the development board.
The Connect Wi-Wave module connector is a 52-pin connector that conforms to the
PCI Express Mini Card Electromechanical Specification, Rev. 1.1, with additional
non-standard connections (to the reserved pins on the standard connector). All the
non-standard connections are routed through switches:
 When the switches are off (default), the development board fully complies
with the PCI Express Mini Card Electrical Specification.
 When the switches are closed, the development board provides access to the
additional signals. Note that these signals are reserved and not intended for
user applications.
Pinout
Note: Signal direction w.r.t PCIe Mini Card.
Connect Wi-Wave module
connector, P52
Pin Type Signal Pin Type Signal
1 n/a No connect 2 In Vcc_3.3
3 n/a No connect 4 In GND
5 n/a No connect 6 n/a No connect
7 n/a No connect 8 Out UIM_PWR (C1)
9 In GND 10 I/O UIM_DATA (C7)