User's Manual

ABOUT THE DEVELOPMENT BOARD
Switches and reset functionality
20 Connect Wi-Wave Hardware Reference, Rev B 9/2007
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Switches and reset functionality
Voltage monitor The development board provides a power supply voltage monitor and reset
generator. When the +3.3V regulated supply voltage drops below 2.93V, the reset
signal — RESET# — is asserted for a minimum of 140 msec. This signal is connected
to the Connect Wi-Wave edge connector (pin 22), as well as to the signal breakout
header for monitoring.
Alternative
methods to trigger
RESET#
In addition to supply voltage monitoring, reset logic can be triggered in two other
ways. The RESET# logic is asserted when you do one of these actions:
 Manually push SW1, a pushbutton reset switch on the development board
 Pull low pin 15 on the JTAG breakout header, P200
Reset switch, S1
JTAG switch, S3
Reset trigger
breakout pin, pin 15