User's Manual

. . . . .
ABOUT THE DEVELOPMENT BOARD
U.FL and RP-SMA connectors
www.digiembedded.com 25
the DISABLE# signal to the module, place a jumper between either pins 18 and 20 or
pins 19 and 21.
As an alternative, you can drive this pin with a low voltage TTL or CMOS driver.
When asserted, DISABLE# lights the DISABLE LED, DS3.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
U.FL and RP-SMA connectors
U.FL connectors The development board has two U.FL connectors that pair with two RP-SMA
connectors. WiFi antenna 1 (P11) pairs with RP-SMA connector J11; WiFi antenna 2
(P12) pairs with RP-SMA connector J12.
???U.FL cables The development kit includes two U.FL-to-U.FL cables that can be used to connect
the module and development board. The number of cables used depends on
whether one antenna is used to transmit and receive or two antennas are used
(diversity receive).
1 Attach one end of the cable(s) to the U.FL connector(s) on the Connect Wi-Wave
module.
RP_SMA WLAN
antenna, J11
U.FL connector,
WiFi antenna 1, P11
U.FL connector,
WiFi antenna 2, P12
RP_SMA WLAN
antenna, J12