User's Manual

 57
Specifications
Notes to original equipment manufacturer (OEM ) integrators
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and
users for all installations, and
2) The transmitter module may not be co-located with any other transmitter or antenna, and
3) The Module is approved using the FCC ‘unlicensed modular transmitter approval’
method.
Therefore the module must only be used with the originally approved antennas. As long as
the 3 conditions above are met, further transmitter testing will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).
NOTE: In the event that any of these conditions can not be met (for example portable
configurations, co-location with another transmitter, or use of a different antenna), then the
FCC authorization is no longer considered valid and the FCC ID can not be used on the
final product. In these circumstances, the OEM integrator will be responsible for re-
evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.