Reference Manual

123 ConnectCore 9M 2443 & Wi-9M 2443 Hardware Reference
Chapter 2
38 I/O I XDACK0#
GPB9
Configured as input, pull-up
enabled
Not used
39 I/O I XDACK1#
GPB7
Configured as input, pull-up
enabled
Not used
40 P - GND GND
41 AI - AIN4 Analog in. Unused analog
inputs should be
connected to AGND over a
10k series resistor
to avoid cross over.
Not used
42 AI -
-
AIN5 Analog in. Unused analog
inputs should be
connected to AGND over a
10k series resistor
to avoid cross over.
Not used
43 AI - AIN0 Analog in. Unused analog
inputs should be connected to
AGND over a 10k series
resistor to avoid cross over.
Not used
44 AI - AIN1 Analog in. Unused analog
inputs should be
connected to AGND over a
10k series resistor
to avoid cross over.
Not used
45 AI - AIN2 Analog in. Unused analog
inputs should be
connected to AGND over a
10k series resistor
to avoid cross over.
Not used
46 AI - AIN3 Analog in, unused analog
inputs should be connected to
AGND over a 10k series
resistor to avoid cross over.
Not used
47 AI - AIN6/YM Used for touch screen
TSYM/JSCC9M2443
Connected to LCD.
Application connector X5.
48 AI - AIN7/YP Used for touch screen
TSYP/JSCC9M2443
Connected to LCD.
Application connector X5.
49 AI - AIN8/XM Used for touch screen
TSXM/JSCC9M2443
Connected to LCD.
Application connector X5.
50 AI - AIN9/XP Used for touch screen
TSXP/JSCC9M2443
Connected to LCD.
Application connector X5.
X2 Typ
e
U-
Boot
Module
Functionality
Comments Usage on
development board